Home > Discussion Groups > Tricks & Tips

Message posting guidelines:
1.

Full real names must be used at all times.

2.
A valid e-mail address must be provided. (This is not optional)
3.
  Images must be posted at low resolution (72 dpi) and no larger than 760 pixels wide, and copyright/trade mark owners must be credited whenever reasonably possible.
4. From 20 April, registration is compulsory if you wish to post messages on the Discussion Boards. For further information, please see the following message: http://www.network54.com/Forum/message?forumid=95064&messageid=1113823324
Please read our Community guidelines before posting.
By contributing to this discussion group, you indicate your agreement to the Terms and Conditions of Use.
Posts that violate the guidelines or Terms and conditions of Use of the Missing-lynx.com discussion groups will be erased, and repeated violation of this policy may result in termination of the violator's account.

  << Previous Topic | Next Topic >>Return to Index  

low speed strong torque drill

July 4 2017 at 11:28 PM
Kevin J McNichols  (Login LCplMac)
Missing-Lynx members
from IP address 96.230.119.249

My dremel is too fast to safely drill plastic without melting the hole and the collets won't take fine drills. My recchargable drill works nicely with larger bits. And I use a jewelers pinvise for wire drills ie #80. But for more numerous work I'd like to find a powered/recargeable tool. I've tried using a small rechargable screw driver with a hex conversion chuck but it runs too eleptically for precise fine work and tends to snap fine wire drill bits.
I saw one once on a site that sold tools for circuit board manufacturing. Anyone have any ideas?

 
 Respond to this message   
AuthorReply
Andrew Tomlinson
(Login AndrewTomlinson)
Missing-Lynx members
82.20.32.126

My old COMO drill still works great for fine work...

July 5 2017, 3:57 AM 

but I'm unsure if still available.

Cheers
Andrew

 
 Respond to this message   
Jon Arnold
(Login jon_a_its)
Missing-Lynx members
194.66.32.16

Old as the Hills

July 10 2017, 4:04 AM 


I have several Como drills, as here:http://www.militarymodelling.com/forums/postings.asp?th=95825

UK Price list dated March 2017, so still current.

Mine had an electronic speed controller which would 'pulse' below say 100 rpm, but still drilled slow enough to not burn out plastic or snap 0.5mm drills.

Other Brands are available, Proxxon, Dremmel etc, but this has served me well for decades.

 
 Respond to this message   
Paul Krylowski
(Login Paulpk222)
Missing-Lynx members
184.6.211.27

Dimmer switch

July 20 2017, 12:00 AM 

Kevin,
I once used a dimmer switch to control a receptacle that I plugged the Dremel into. I built it in a double electrical box. It slowed the Dremel down considerably.
Paul

 
 Respond to this message   
 
  << Previous Topic | Next Topic >>Return to Index  


Terms and Conditions of Use
Report abuse